arrow_back
Introduction and Surface Creation
1) Introduction To Surface Modelling
2) How To Invoke Surface Environment
3) Surface Continuities- G0, G1, G2, G3
4) Class Of Surfaces
5) Primitives- Block, Cylinder, Cone, Sphere
6) Extrude
7) Revolve
8) Sweep Along Guide, Variational Sweep
9) Swept
10) Styled Sweep
Surface Creation
1) Through Curves
2) Through Curve Mesh Tool
3) Studio Surface
4) N-Sided Surface
5) Bounded Plane
6) Fill Surface
7) Four Point Surface
8) Law Extension
9) Extension Surface
10) Silhouette Flange Surface
Surface Operation
1) Offset Surface
2) Snip Surface
3) Trim Sheet
4) Untrim
5) Extend Sheet
6) Trim And Extend
7) Sew
8) Unsew
9) Patch
6) Trim And Extend
7) Sew
8) Unsew
9) Patch
10) Thicken
Derived Curve
1) Intersection Curve
2) Section Curve
3) Isoparametric Curves
4) Isocline Curve
5) Composite Curve
6) Curve On Surface
7) Offset Curve In Face
8) Combined Curve Projection
9) Bridge Curve
10) Project Curve
Surface Blends
1) Edge Blend
2) Face Blend
3) Aesthetic Face Blend
4) Aesthetic Face Blend
5) Bridge Surface
Practice Exercise
1) Modelling Strategy
2) Practice Exercise-1
3) Practice Exercise-2
4) Practice Exercise-3
6) Practice Exercise-5
7) Practice Exercise-6